Claude Cracks 32-Year-Old Jeep ECU Using a $3 Arduino and Reverse Engineers Its Engine Computer

Blog WriterCybersecurity News - Original News Source is cybersecuritynews.com


A car owner says an AI coding agent helped him read, copy, and then run code inside the engine computer of a 1994 Jeep Cherokee. The work took about a week. He used a $3 Arduino Nano, and the Jeep passed California’s smog test at the end. Muhammad Zulali shared the full story in a YouTube video on November 10, 2026.

The Jeep had no modern OBD2 port, so common scan tools could not talk to it. It failed the smog test at 25 mph because of high NOx, a gas that rises when an engine runs lean. Zulali first swapped the oxygen sensor, but the result got worse at 15 mph. Each test cost about $100, so he asked Claude Code to find a better way.

Claude found that the engine computer speaks an old, slow Chrysler protocol called SCI. The signal wire is flipped compared with a normal serial port, so a small translator was needed. A $3 Arduino Nano on a breadboard did the job, and the full parts list came to about $15.

Claude Cracks 32-Year-Old Jeep ECU

Tom’s Hardware reported that the link ran at about 7,800 baud. Only three wires from the six-hole diagnostic plug were used. One hole carries 12 volts with the key on, and touching it can fry the board.

The first reading came at 1:30 a.m. and showed only coolant temperature and battery voltage. Later data looked odd, with a fuel trim that seemed to add 22 percent extra fuel. Zulali tested fuel pressure and found a very low 10 PSI.

Claude then switched the fuel pump on by itself for about 10 seconds. He called this the moment the tool went from read-only to controlling the car.

The AI also made a mistake, and the cause was a public tool. Claude later found that the ChryslerScanner parameter table was wrong for his Jeep. The computer was removing fuel, not adding it. The scanner’s author, László Dániel, is credited in the project for the parameter tables.

Next, Claude copied the engine computer’s whole program to a laptop. The code showed a California-only fuel table that cuts fuel at the same load used in the smog test. This likely explained the high NOx. Reflashing the chip was the obvious fix, but the computer was built in December 1993, about four months too early to be reflashable.

That is where OpenAI’s Codex stepped in. It found a way to send a tiny program over the same three wires and have the computer run it. The first version was wiped out within seconds, so Codex moved the code into EEPROM, a memory that survives a dead battery. Zulali said Claude did most of the diagnosis and Codex did the memory work, while he handled wiring and driving.

The project is open source under the GPLv3 license. The xj-scanner repository on GitHub had 252 stars and 30 forks at the time of writing. It was tested on one car, a 1994 Cherokee XJ with a 4.0L engine, and the author warns that use is at your own risk.

For security readers, the lesson is about how fast AI agents can learn forgotten systems. Researchers once showed that car computers could be pushed to turn off brakes through physical access. Agents now cut the skill and time needed for that kind of work.

Our earlier report on Claude Code finding a hidden model backdoor shows the same pattern. Agents also carry their own risk, as seen when hackers hijacked Codex and Claude Code with files in Downloads. Anthropic’s Claude Code security guide advises users to review commands before approval.

Zulali admits he is not a mechanic and that some of his engine claims may be wrong. The owner reported the result himself, so it has not been independently tested.

Give your SOC the alert context to stops incidents quickly. Integrate Threat Intel from 16K SOCs.

The post Claude Cracks 32-Year-Old Jeep ECU Using a $3 Arduino and Reverse Engineers Its Engine Computer appeared first on Cyber Security News.